Screen Capture - Simrad NSO evo3S MPU Operator's Manual

16
You select Standby mode from the System Controls dialog.
Switch from Standby mode to normal operation by a short press on the Power key.
Display illumination
Brightness
You can cycle the preset backlight levels by short presses on the Power key.
The display backlighting can also be adjusted from the System Controls dialog.
Night mode
The night mode can be activated from the System Controls dialog.
The night mode option optimizes the color palette for low light conditions.
Locking the touchscreen
You can temporarily lock a touch screen to prevent accidental operation of the system.
You can only lock the touch screen if there is a remote controller with a power key
connected to the NMEA 2000 network. This will prevent permanent lock-out.
You lock the touch screen from the System Controls dialog.
When the touch lock is active, you can still operate the unit from the remote controller.
You remove the lock function by pressing the power key on the remote controller.
Instrument bar
Toggles the Instrument bar on/off for the current page only.

Screen capture

You enable/disable the screen capture option in the system settings dialog.
To take a screen capture:
• Double-tap the status bar or the dialog title
• Keyboard operation: press the PrintScrn key or press Ctrl + \
Screen captures are saved to internal memory.
Basic operation | NSO evo3S MPU Operator Manual