Preface; About This Document; How To Use This Document; Important User Information - HMS EtherCAT Slave Addendum

X-gateway interface

Table of Contents

This document describes network specific features and procedures needed when operating the Ether-

CAT Slave Interface for the Anybus X-gateway. For general information and operating instructions for

the Anybus X-gateway, consult the Anybus X-gateway User Manual.

The reader of this document is expected to be familiar with EtherCAT networking technology, and com-

munication systems in general.

For further information, documentation etc., please visit the HMS website, 'www.anybus.com'.

The data and illustrations found in this document are not binding. We, HMS Industrial Networks AB,

reserve the right to modify our products in line with our policy of continuous product development. The

information in this document is subject to change without notice and should not be considered as a com-

mitment by HMS Industrial Networks AB. HMS Industrial Networks AB assumes no responsibility for

any errors that may appear in this document.

There are many applications of this product. Those responsible for the use of this device must ensure

that all the necessary steps have been taken to verify that the application meets all performance and safe-

ty requirements including any applicable laws, regulations, codes, and standards.

Anybus® is a registered trademark of HMS Industrial Networks AB. All other trademarks are the prop-

erty of their respective holders.

Warning:

ESD Note:

This is a class A product. In a domestic environment this product may cause radio interfer-

ence in which case the user may be required to take adequate measures.

This product contains ESD (Electrostatic Discharge) sensitive parts that may be damaged

if ESD control procedures are not followed. Static control precautions are required when

handling the product. Failure to observe this may cause damage to the product.

Preface

Table of Contents

Do you have a question about the EtherCAT Slave and is the answer not in the manual?