Standard Test Area Enclosure Operation; Hydraulic Power Off; Specimen Installation And Setup - MTS Systems Landmark 370 Series Product Information

Item Control/Indicator Description
6 Stop
7 Connector
8 Hydraulic Off
9 Start
10 Interlock Reset
11 Thumbwheel
Enable
12 Fault
13 Handset Enable
14 Select (Enter)
15 Display

Standard Test Area Enclosure Operation

There are four operating modes for an MTS Landmark Test System:

Hydraulic Power Off

l

Specimen Installation and Setup

l
Run Mode
l
Service
l

Hydraulic Power Off

Hydraulic Power is prevented from energizing the circuit via the hydraulic service manifold. Full access
to the test area is allowed in this mode.

Specimen Installation and Setup

The controller provides a means for creating a specimen installation mode. This mode typically uses
the Channel Limited Channel (CLC) control method. The primary control channel is Displacement
(stroke) with maximum limits set on applied force. Tuning parameters unique to this mode optimize
manual control during this mode. In addition, a maximum velocity command is set.
The handset has the ability to have a configuration specific desired response to the thumbwheel
encoder on the handset for a precise level of control.
MTS Landmark™ Tabletop Load Units - Product Information
Stops the test action. Only if the application test software is active.
RJ-45, to Controller.
Shuts down the HPU.
Starts the test action. Only if the application test software is active.
Resets active interlock(s) providing the cause for the interlock(s)
has been remedied.
Press to enable the thumbwheel to position the actuator. Press
again to disable the thumbwheel. The indicator lights when the
thumbwheel is active.
Indicator. When lit, indicates an active fault or interlock.
Used to enable/disable the handset. When the indicator is lit, the
handset is enabled for control of the actuator.
Selects the highlighted line in the display.
Four lines, 20 characters per line.
Operation
75