Practice Good Housekeeping; Protect Hoses And Cables; Provide Proper Hydraulic Fluid Filtration; Protect Accumulators From Moving Objects - MTS Systems Landmark 370 Series Product Information

Safety
On rare occasions, a fastener can fail even when it is correctly installed. Failure usually occurs during
torquing, but it can occur several days later. Failure of a fastener can result in a high velocity projectile.
Therefore, it is a good practice to avoid stationing personnel in line with or below assemblies that
contain large or long fasteners.

Practice good housekeeping

Keep the floors in the work area clean. Industrial chemicals, such as hydraulic fluid, that are spilled on
any type of floor can result in a dangerous, slippery surface. Do not leave tools, fixtures, or other items
not specific to the test lying about on the floor, system, or decking.

Protect hoses and cables

Protect electrical cables from spilled fluids and from excessive temperatures that can cause the cables
to harden and eventually fail. Ensure that all cables have appropriate strain relief devices installed at
the cable and near the connector plug. Do not use the connector plug as a strain relief.
Protect all system hoses and cables from sharp or abrasive objects that can cause the hose or cable to
fail. Use a cable cover or cable tray where cables are in traffic locations. Never walk on hoses or cables
or move heavy objects over them. Route hoses and cables away from areas that expose them to
possible damage.

Provide proper hydraulic fluid filtration

For hydraulic systems equipped with a non-MTS hydraulic power unit, make sure that hydraulic fluid
filtration is established to maintain fluid cleanliness standards as stated in the Hydraulic Fluid Care
Manual (see the System Documentation CD). Particles present in the hydraulic fluid can cause erratic
or poor system response.

Protect accumulators from moving objects

For systems equipped with accumulators, protect accumulators with supports or guards. Do not strike
accumulators with moving objects. This could cause the accumulator(s) to separate from the manifold,
resulting in equipment damage and personal injury.

Record changes

If you change any operating procedure, write the change and the date of the change in the
appropriate manual.

Provide test area guards

Use protective guards such as cages, enclosures, and special laboratory layouts when you work with
hazardous test specimens (for example, brittle or fragmenting materials or materials that are
internally pressurized).

Do not exceed the Maximum Supply Pressure

For hydraulic systems and components, make sure that hydraulic supply pressure is limited to the
maximum pressure defined by the system operating limits. Read and review "System Operating
Limits" for the system.
20 MTS Landmark™ Tabletop Load Units - Product Information