Control Module - MTS Systems Landmark 370 Series Product Information

Operation

Control Module

The controls for the Series 370 Load Unit are located on a module mounted to the front of the load unit.
The followingcontrol panel is shown with all available options. The control panel on your load unit might
not have all of these controls depending on the specific configuration.
Item Control
1 Upper Hydraulic Grip
Controls
2 Lower Hydraulic Grip
Controls
3 Grip Pressure Adjust
4 Crosshead Lock/Unlock
Control
5 Crosshead Positioning
Control
64
Series 370 Load Unit Controls
Description
Item 1 controls clamping and unclamping the optional upper
hydraulic grip. Item 1A adjusts the upper grip clamping rate. Item
1B is the upper grip pressure gage.
Item 2 controls clamping and unclamping the optional lower
hydraulic grip. Item 2A adjusts the lower grip clamping rate. Item
2B is the lower grip pressure gage.
Adjusts the amount of hydraulic pressure to the grips. The
adjustment range is 1–21 MPa (100–3000 psi) or 1–69 MPa (100–
10,000 psi). The highest pressure setting depends on the
maximum pressure setting. Adjust the control clockwise to
increase the hydraulic pressure. Use the pressure gage and the
grip manual to determine the necessary clamping force.
Controls the locking and unlocking of the crosshead. The
crosshead must not be moved while it is clamped.
Controls the movement of the crosshead. The control raises and
lowers the crosshead. The crosshead must not be moved while it
is locked.
MTS Landmark™ Tabletop Load Units - Product Information