Table of Contents
Advertisement
Categories legend (resetting the error)
a) The error message will disappear once the error has been rectified.
b) The error message can be reset by pressing a push-button:
Welding machine control
RC1 / RC2
Expert
Expert 2.0 / Expert XQ 2.0
CarExpert / Progress (M3.11)
alpha Q / Concept / Basic / Basic S / Synergic /
Synergic S / Progress (M3.71) / Picomig 355
c) The error message can only be reset by switching the machine off and on again.
The shielding gas error (Err 6) can be reset by pressing the "Welding parameters" key button.
099-005507-EW501
13.09.2018
Rectifying faults
Error messages (power source)
Push-button
not possible
95
Advertisement
Table of Contents
Need help?
Do you have a question about the drive 4X IC D HP and is the answer not in the manual?
Questions and answers