RS-232C Command Control
The basic control parameters are as follows.
Item
Scanning
Electronic Shutter
Gain
Black
Trigger
Miscellaneous
Field Upgrade Function
You can update the firmware using the dedicated update tool via Camera Link serial communication.
Serial communication via the DC IN / trigger IN connector (12-pin round) is not supported for this function.
Control parameter
Independent scanning for all pixels, binning
Accumulation time
Gain Value
Black offset value
Mode, trigger polarity selection
Camera Link: 8- ⇔ 10-bit switching
Test pattern: ON ⇔ OFF
̶ 37 ̶
SW-4000M-PMCL