Table of Contents
Advertisement
Cameleon Spot Q4
Multiple Cameleon Spots (Master/Slave control)
Multiple Cameleon Spots (DMX Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Cameleon Spots and other devices.
04) Link the units as shown in fig. 04. Connect a light controller to the first unit's DMX "in" socket, using the
42708 – DMX input cable. Connect the first unit's "out" socket with the second unit's "in" socket, using
the 42707/427076 – DMX Extension cable, Link the second, third and fourth unit using the
42707/427076 – DMX Extension cable.
05) Supply electric power: Plug electric mains power cords into each unit's special IP65 power IN socket,
then plug the other end of the mains power cord into proper electric power supply sockets, starting
with the first unit. Do not supply power before the whole system is set up and connected properly.
Ordercode: 42673
10
Fig. 03
Advertisement
Table of Contents
