Table of Contents
Advertisement
Multiple Cameleon Spots (DMX Control)
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
Plug the end of the electric mains power cord into a proper electric power supply socket.
3.
Use a 3-p XLR cable to connect the Cameleon
4.
Link the units as shown in (figure 4), Connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
5. Supply electric power: Plug the end of the mains power cord into proper electric power supply
sockets. Do so for all units and the controller.
Note : Link all DMX cables and set dip switches before connecting electric power
6. Do not supply power before the whole system is set up and connected properly. Design your show
according to your DMX controller functions. See page 13 for more about DMX programming.
Multiple Cameleon Spots (Master/Slave control)
Multiple Cameleon Spots Pro Set Up
Max. 30 Cameleon Spots
Spots.
9
Fig. 3
Fig. 4
Advertisement
Table of Contents
