3 609 929 B37/2008-09 | IM24V
1 About this document
About this document
These instructions contain important
information on the safe and appropriate
assembly, transportation, commissioning,
operation, maintenance, disassembly and
simple troubleshooting of the IM24V
Read these instructions completely,
especially the chapter "2 General safety
instructions" on page 17, before working
with the IM24V interface module.
The IM24V interface module is a system
Also observe the instructions for the other
Also observe the generally applicable, legal
or otherwise binding regulations of the
European or national legislation and the rules
for the prevention of accidents and for
environmental protection applicable in your
The IM24V interface module has been
manufactured according to the accepted
rules of current technology. There is,
however, still a danger of personal injury or
damage to equipment if the following general
safety instructions and the warnings before
the steps contained in these instructions are
not complied with.
• Read these instructions completely and
thoroughly before working with the IM24V
• Keep these instructions in a location where
they are accessible to all users at all times.
Bosch Rexroth AG
• Always include the operating instructions
when you pass the IM24V interface
module on to third parties.
The IM24V interface module is a component
in terms of the machine directive 98/37/EC
(partial machine). The product is exclusively
intended for being integrated in a machine or
system or for being assembled with other
components to form a machine or system.
The product may be commissioned only if its
integrated in the machine/system for which it
is designed and the machine/system fully
complies with the EC machine directive.
Observe the operating conditions and
performance limits specified in the technical
The IM24V interface module is a work
appliance and not designed for private use.
Intended use includes having read and
understood these instructions, especially the
chapter "2 General safety instructions".
The IM24V interface module is intended for
installation in components for the Tightening
Any use of the IM24V interface module other
than described in chapter "Intended use" is
considered as improper.
Assembly, commissioning and operation,
disassembly, service (including maintenance
and repair) require basic electrical and
mechanical knowledge, as well as
knowledge of the appropriate technical
terms. In order to ensure operating safety,
these activities may therefore only be carried
out by qualified technical personnel or an
instructed person under the direction and
supervision of qualified personnel.