Operation, Readers With Keypad; Authorization Process; Sequence Of Operation - Honeywell Accentic 026423 Operating Instructions Manual

26
6.4

Operation, readers with keypad

6.4.1

Authorization process

There are different possibilities of calling functions. Which of these possibilities is used, is defined
in the programming of the central control unit/EU.
"ID" refers to any data carrier or substitude code, authorized in the system.
The following table provides an overview.
Function
Arm
Disarm
Hold-up alarm
AC-Functions
Control functions
Info
(X) Depends on the authorization of disarm and/or access control function (see 6.4. ).
Quick
Only PIN
Only ID
PIN or ID
PIN + ID
6.4.2

Sequence of operation

If both the PIN and data carrier are required for a function, the sequence of operation can take
place in two ways:
0....9
First enter the PIN
ID
Hold the data carrier in the reading field
or
ID
First, hold the data carrier in the reading field
0....9
Enter PIN
In order for these instructions to remain manageable, the following chapters are limited to
presenting the variation for entering the PIN first.
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
Quick
X
X
X
"
With the quick function, only the corresponding function key requires activating
(arm / disarm / function "F"). A PIN or data carrier is not required.
The function can be triggered after entering the PIN.
The function can be triggered after reading a valid data carrier.
PIN or data carrier are required to trigger the function.
PIN and data carrier are required to trigger the function.
only PIN only ID
X X
X X
X
X X
X X
" "
PIN or ID PIN + ID
X X
X X
(X)
X X
X X
X
" 5