Access Control; Combination Disarm / Ac Function; Learning Mode For Data Carriers - Honeywell Accentic 026423 Operating Instructions Manual

34
6.5.2 Access control function
- Hold data carrier in the reading range.
- Acknowledgement.
Acknowledgement
with AC function:
6.5.3

Combination disarm / AC function

- Disarm first (see 6.5.1).
- For the AC funciton, hold the data carrier for a
or
- AC function will automatically be activated after disarming.
6.5.4 Learn mode
Learn mode is used for the simple authorization of new data carriers.
In order to start and exit the learn mode, a
master key" is a data carrier that is defined exclusively in the system for this purpose.
As long as the learn mode is activated,
The "Alarm" indicator is used in the learn mode as an optical acknowledgement signal. It lights up
green, as long as the learn mode is activated. It flashes briefly to acknowledge an action that has
been performed. (s.b.).
The learn mode can only be activated in a
If an action cannot be performed, negative acknowledgement follows!
Required Firmware:
- IK3 EU BUS-2
- IK3 EU conventional
- Door controller module for MB
Start learn mode
Learn data carrier
Quit learn mode
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
Optical
Ready (green)
Disarmed
Acoustical
(signal)
Action
any number of actions
disarmed state.
from V05.xx upward
from V01.05 upward
from V10.xx upward
Hold the learn master key in the reading range
The "Alarm" indicator lights up green
The actions can now be performed.
Hold new data carrier in the reading range
"Alarm" indicator flashes 1x
Hold the learn master key in the reading range
"Alarm" indicator goes off
Authorized
5 sec.
(yellow)
2 sec.
Positive acknowledge.
Time-controlled
door release
third time
"Learn master key"
can be performed successively.
No authorization or
AC function not activated
Negative acknowledge.
No door release
in the reading range
is required. This so-called "learn
green
green
green