Download Print this page

Access Control; Hold-Up Alarm; Hold-Up Code; Trigger Hold-Up Alarm In "Disarmed" State - Honeywell Accentic 026423 Operating Instructions Manual

Mifare-reader; mifare desfire ev1 reader
Hide thumbs

Advertisement

Table of Contents
28
6.4.4

Access control

0....9
Enter PIN
and
or
ID
Hold the data carrier in the reading range
6.4.5

Hold-up alarm

6.4.5.1
Introduction
A
hold-up alarm
can be triggered via the operating unit keypad with a hold-up code.
The

hold-up code

is identical with the PIN with the exception of the last digit.
last digit.
(Other digits can be defined via the system programming ).
Example
: PIN
Hold-up code
The hold-up code is thus
A possible tens digit is
A hold-up alarm is triggered irrespective of whether the system is in an armed or disarmed state.
Even if the operating unit is used for AC functions, a hold-up alarm can be triggered.
6.4.5.2

Trigger hold-up alarm in "disarmed" state

0....9
Enter the hold-up code
ID
Hold the data carrier in the reading range
With authorization: A hold-up alarm is triggered
Acknowledgement:
In case of a hold-up alarm without door release, an acoustic negative acknowledgement
takes place (triggered by the deactivated access control function).
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
456789
45678
456784
not carried over.
Authorization
Ready
(green)
Disarmed
(yellow)
9+5 4
=
possible without door release
No authorization
5 sec.
5 sec.
possible
A 5 is added to the
possible with door release
Digit

Advertisement

Chapters

Table of Contents
loading