Download Print this page

Honeywell CN80G Quick Start Manual

Cac reader
Hide thumbs


Quick Links

CN80G CAC Reader
and Ethernet Base
Quick Start Guide
CN80G-CAC-EN-QS-01 Rev A



  Also See for Honeywell CN80G

  Summary of Contents for Honeywell CN80G

  • Page 1 CN80G CAC Reader and Ethernet Base Quick Start Guide CN80G-CAC-EN-QS-01 Rev A 04/19...
  • Page 2: About The Common Access Card Reader

    Honeywell Updater app. The OTA version number installed on the computer appears on the screen. The OTA version must be 85.06.00-(0145) or higher. How to install OTA updates can be found in the Dolphin CN80G User Guide on
  • Page 3: About The Status Led

    About the Status LED Status LED Status Description Flashing Green The reader is connected to CN80G. Solid Green The reader is reading a common access card. Install the CN80G CAC Reader...
  • Page 4: Remove The Cn80G Cac Reader

    Remove the CN80G CAC Reader Insert the Card Insert a common access card into the slot with the contact pins facing up.
  • Page 5: Ethernet Base

    Connect Power Use only a UL Listed power supply which has been qualified by Honeywell with an output rated at 12 VDC and 3 A. The power supply input rating is 90-264 VAC, 50/60 Hz. The operating temperature is -20 °C to 40 °C (-4 °F to 104 °F). The maximum output of the terminal is 9VDC/2A.
  • Page 6 Charge the Battery Pack Insert a battery pack into the base.
  • Page 7: About The Status Leds

    About the Status LEDs Note: The Dolphin CN80G with an attached CAC Reader can only be used with the CAC Reader Ethernet Base. Dock LED Ethernet LED Battery LED Status Description Ethernet Solid CN80G is connected to an Ethernet network.
  • Page 8 Status Description Battery Solid The battery is connected to external power Status Green and is fully charged. Solid The battery is connected to external power Amber and is charging. Blinking There is a battery charging fault, such as over-temperature.
  • Page 9 Mount the Base You can mount the base on a flat, horizontal surface such as a desktop or workbench with an optional DIN rail. Mounting hardware required: • DIN rail • 3/16-inch diameter x 5/8-inch long pan head screw • 1/2-inch OD x 7/32-inch ID x 3/64-inch thick washer •...
  • Page 10: Product Documentation

    Patents For patent information, see Disclaimer Honeywell International Inc. (“HII”) reserves the right to make changes in specifications and other information contained in this document without prior notice, and the reader should in all cases consult HII to determine whether any such changes have been made.
  • Page 11 Copyright  2019 Honeywell International Inc. All rights reserved.