Download Print this page

Creating/Changing Pins - Honeywell Accentic 026423 Operating Instructions Manual

Mifare-reader; mifare desfire ev1 reader
Hide thumbs

Advertisement

Table of Contents
32
6.4.9

Creating/Changing PINs

The manner for using PINs depends on the programming of the evaluation unit:
Each data carrier is assigned an individual PIN. Multiple data carriers cannot have the same
PIN.
or
The use of one PIN for multiple data carriers is possible.
Please note the following when creating or changing PINs:
A PIN may have 4 to 8 digits.
All PINs used in a system must have the same number of digits. The required number of digits is
defined by the installer according to the security requirements of the object.
An acoustic
negative acknowledgement
exists (and multiple use is not allowed) or the PIN corresponds to a hold-up code.
i
Define PIN
ID
3
0....9
3
0....9
3
Alter PIN
ID
3
0....9
0....9
3
0....9
3
Operating Instructions mifare/DESFire EV1 reader "Accentic" with/without keypad
Activate the " " key
Hold the data carrier in the reading range
The current status will be shown (see "Info" 6.4.7)
Activate "OK"
"Alarm" indicator lights up green
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK"
"Alarm" indicator goes off
Activate the " " key
i
Hold the data carrier in the reading
The current status will be shown (see "Info" 6.4.7)
Activate "OK", "Ready" indicator flashes 1x
(partial admittance)
Enter current PIN, "Alarm" indicator lights up green
(Alter PIN mode active)
Enter new PIN
Activate "OK"
Re-enter PIN
Activate "OK", "Alarm" indicator goes off,
"Ready" indicator lights up for 2 sec.
takes place if there is no authorization, if the PIN already
i
i
Alarm
green
Alarm
green
Ready
green
Alarm
green
Ready
green
Alarm
green

Advertisement

Chapters

Table of Contents
loading