Connection Status - Pptp - Sitecom DC-202 Full Manual

DC-202 xDSL/Cable Broadband router

Connection Status - PPTP

If using PPTP (Peer-to-Peer Tunneling Protocol), a screen like the following
example will be displayed when the "Connection Details" button is clicked.
Data - PPTP Screen
Connection
Physical Ad- The hardware address of this device, as seen by remote devices on
the Internet. (This is different to the hardware address seen by
dress
devices on the local LAN.)
IP Address The IP Address of this device, as seen by Internet users. This ad-
dress is allocated by your ISP (Internet Service Provider).
PPTP Status This indicates whether or not the connection is currently established.
•
•
Connection Log
•
Connection
Log
•
Buttons
Connect If not connected, establish a connection to your ISP.
Disconnect If connected to your ISP, hang up the connection.
Clear Log Delete all data currently in the Log. This will make it easier to read
new messages.
Refresh Update the data on screen.
If the connection does not exist, the "Connect" button can be
used to establish a connection.
If the connection currently exists, the "Disconnect" button can
be used to break the connection.
The Connection Log shows status messages relating to the
existing connection.
The "Clear Log" button will restart the Log, while the Refresh
button will update the messages shown on screen.
37