Table of Contents
Advertisement
6.3.3 Calling the menu
The Comfort hand switch provides various possibilities for settings, which can be carried out by the operator
himself (
and
To do so, press the "Logo" key for 6 seconds till the display changes to
You can navigate with the arrow keys in the menu that is displayed thereupon.
Menu structure:
– Change the height display (inches – cm)
– Adjust the height display
– Factory reset
– Set shelf and container stop
– Delete shelf and container stop
To go to the sub-menu, confirm once with the "Logo" key.
6.3.4 Changing the unit of the height display (menu F1)
The height can be shown in centimetres or inches on the hand switch. The unit can be toggled in the menu.
To change the unit, proceed as follows:
1. Press the "Logo" key for 5 seconds.
2. Confirm menu option
3. Now, select with the
a. key "Up arrow"
b. key "Down arrow"
4. Confirm the selection by once again pressing the "Logo" key.
To quit the menu without making a selection, wait for about 10 seconds till the height display appears again.
This setting is stored permanently.
6.3.5 Calibrating the height display (menu F2)
If the displayed height does not tally with the actual height of the table-top, the display can be corrected as
follows:
1. Press the "Logo" key for 5 seconds.
2. With the "Up" and "Down" keys, select the menu option
the "Logo" key. The display and the edge lighting now start to flash.
3. Measure the actual current table height and correct the height being currently shown in the display with the
"Up" or "Down" keys to the measured height.
4.
Confirm the input by briefly pressing the "Logo" key.
To quit the menu without making a selection, wait for about 10 seconds till the height display appears again.
9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
are not always enabled).
by once again pressing the "Logo" key.
: inches, or
: cm.
.
. Confirm this selection by once again pressing
18
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
