Fitting The Skids; Assembly Of The Desktop - OMT FREE.STAND 9051 Installation And Operating Instructions Manual

4.2 Fitting the skids

If the side frame has skids welded to it, please continue with point 4.2.
If the side frame has screwed-on skids, they must first be fitted to the mounting legs. To do so, use the screws
as given in the table-top support frame drawing.
The max. tightening torque is 10 Nm!
The max. screw-in depth of the screws M10 into the drive column is 12 mm.
With asymmetric skids (C-form), keep in mind that one left and one right side frame might be required.

4.3 Assembly of the desktop

Now fasten the desktop to the desk base in accordance with the base drawing. To accomplish that, ø7.0 mm
holes are provided on the desk frame; they are suitable for ø5.5 to ø6.5 mm bolts. Use all provided bolting
points. *1)
9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB
Column
M10 bolt
as per base drawing
Optional pressure plate
Run
11