Commissioning; Connections To The Stand.control C1 Motor Controller - OMT FREE.STAND 9051 Installation And Operating Instructions Manual

5

Commissioning

Commissioning includes all jobs that are necessary for electrical height adjustment of the FREE.STAND
sit/stand desk with the aid of the STAND.CONTROL motor controller. The prerequisites for commissioning are:
•
complete assembly of the desk base in accordance with Section 4.1-4.3
•
and correct installation of the STAND.CONTROL motor controller and hand-switch in accordance
with Section 4.4!
Danger: Only expert/authorised personnel are allowed to commission the motor controller!
Expert/Authorised personnel have completed the required electrotechnical apprenticeship and are
familiar with these operating instructions.
Attention: Before assembly and commissioning of the FREE.STAND sit/stand desk, make sure
the product is acclimatised for the temperature and relative humidity values stated in the technical
data!

5.1 Connections to the STAND.CONTROL C1 motor controller

Attention: Only use 2-pole power supply cables/mains cables supplied by Oelschläger
Metalltechnik.
Using other power cables can cause damage to the controller.
Attention:All connectors are designed exclusively for working with the components supplied by us.
If components or cables not supplied by us are connected, the motor controller or the connected
component can get damaged.
9051_Bedienungsanleitung_C1_Rev2_EN_UK – Stand 08.08.2018 TS / MB

Socket C7 for the mains cable, 2-pole (AC)

Connections 8-pole for the motors

Sockets RJ45 for hand switches (MS) and sensor
13