Trouble Shooting; First Check; It Is Impossible To Activate The Main Contactor - Akerstroms REMOTUS JUPITER Era 4B Installation Manual

Trouble shooting

10 Trouble shooting
10.1

First check

On push button transmitter:
Ensure that a charged battery is inserted in the transmitter.
The status indicator indicates following:
• Slow green flashing means that the transmitter is fully operational
• Fast yellow flashing means that the battery needs charging
• Steady yellow light means that the transmitter is in configuration mode
• Steady red light at start up means that the transmitter is PIN locked
• Steady red light during operating means that an error in the transmitter
has been discovered and it will shut itself down
In receiver:
• Check the indications of mode "Error", "MC activated" and "System OK",
see Table 6 on page 30.
10.2

It is impossible to activate the main contactor

The transmitter has not been paired with the receiver. For LED position see Figure 12.
Indication Squelch (LED 4) is flashing or lit but the transmitter is off.
• This means that some or all frequencies are used. Try an alternative frequency setting.
Indication Message received (LED 3) does not flash and the transmitter is on.
• Check the antenna on the receiver.
• All the settings are correct on both the transmitter and the receiver; the system must be checked by
authorised personnel.
Indication Message received (LED 3) lit and indication LED 5 lit but the main contactor remains deactivated.
• Check the instructions in the operator's manual dealing with activation of the main contactor. Nor-
mally the horn/siren push button must be pressed to activate the main contactor. At start up the push
buttons or joystick must be in not activated position.
• A fault in the receiver prevents the main contactor to be activated.
Installation manual Remotus Jupiter 10BD, Era 4/6/8B FSK16 Version: B0 Document-ID: 954045-000 EN
32 (48)
Author: SH