Prerequisites
You must log on to the Global Configuration and Interface Configuration modes in the
ACLI.
Procedure steps
1. Disable PoE power administration for each slot (for example, slot 7) by using the
2. Enable PoE power administration for each slot by using the following command:
3. Disable power administration for each slot (for example, ports 7/11-7/48) by using
4. Enable PoE power administration for each slot by using the following command:
Configuring PoE
Configure PoE on the Ethernet Routing Switch 8300 for proper power management.
Configuration — Power over Ethernet
following command:
ERS-8310(config)#
poe shutdown slot 7
ERS-8310(config)#
no poe shutdown slot 7
the following commands:
ERS-8310:5(config)#
interface FastEthernet 7/11-7/48
ERS-8310:5(config-if)#
poe shutdown 7/11-7/48
ERS-8310:5(config)#
interface FastEthernet 7/11-7/48
ERS-8310:5(config-if)#
no poe shutdown 7/11-7/48
Configuring PoE
May 2011
67