Setting The Poe Card Power Allocation Priority; Setting The Poe Card Power Limit - Avaya 8300 Configuration

PoE configuration using the CLI
Variable

Setting the PoE card power allocation priority

Set the priority for card power allocation to receive the appropriate power on the card.
Procedure steps
Set the priority for card power allocation by using the following command:
config poe card <slotlist> power-priority
Important:
If power is lost in one of the power supplies that affects the distribution of power among the
cards, the card with the highest priority receives allocated power while the card with the
lowest priority may not be allocated power.
If cards have the same priority setting, the lowest card (slot) ID has the highest priority.
Variable definitions
Use the data in the following table to help you use the config poe card <slots> power-
priority command.
<low|high|critical>
power-priority

Setting the PoE card power limit

Set the card power limit for the power allocation by increasing or decreasing the amount of
PoE power.
42 Configuration — Power over Ethernet
Any consumption that falls below this threshold generates a
warning message stating that the consumption is below the
threshold. This message is sent to the console and log file.
Any consumption above this threshold generates a warning
message stating that the consumption is above the
threshold. This message is sent to the console and log file.
Variable
Priority for power allocation. The priority can be low,
high, or critical. The default is low.
Sets the card priority for power allocation.
Value
Value
May 2011