Travis Industries 96100150 Manual

Packing List

•
Rear Fireback
•
(2) Side Firebacks
NOTE The firebacks are 2-sided. When installing, use the desired pattern.

Installation

WARNING Turn off gas to the appliance and make sure it has fully cooled prior to conducting service.
1 Remove the glass frame and logs (see the manual for details).
IMPORTANT INSTALLATION NOTE FOR MODELS USING THE ACCENT LIGHT:
Follow the steps below if installing the firebacks with an accent light.
a) Remove the burner (see the manual for details).
b) Install the rear fireback (see the directions below).
c) Install the accent light (see the directions included with the kit).
d) Replace the burner.
e) Install the side firebacks (see the directions on the following page).
2 Install the rear fireback following the directions below.
Hold the rear fireback face down,
slide the top behind the baffle on
top of the firebox, and pivot it back
into place. It rests on the shelf at
the back of the firebox.
Page 1 of 2
DVL Insert Firebacks 2-Sided (2005)
SKU # 96100150 - Brick or Herringbone
NOTE: make sure the mortar line on the
edge of the fireback is positioned on the
lower edge. It may be facing inwards or
outwards, depending upon which brick
pattern is facing outwards.
11/28/05 Travis Industries, Inc.