Travis Industries Olympic Quick Start Manual

SKUs

Custom Panel 96100591
Small Panel 96100464
Medium Panel 9600465

Packing List


Panel

(2) Panel Mounting Brackets

Upper "L" Bracket

(4) 10-24 x ½" Thread-Cutting Screws

(2) 10-24 Nuts

(2) 10-24 x ½" Machine Screws (Truss Head)

Drill Bit

Installation

1. The insert should be in position, but pulled out slightly to allow access to the sides and top of the insert.
2. Attach the side bracket to the side of the insert using the thread-cutting screws as shown below (both
sides) – make sure to use the correct holes (cooktop or standard).
NOTE: The brackets have slotted holes. Align the brackets flush with the front of the convection chamber
before tightening the screws.
Make sure to use the correct mounting holes. If using the top air chamber extension,
use the forward holes, if not (cooktop version) use the rear holes.
Button Plugs
(pry out with a screwdriver)
Page 1 of 2
Olympic 1 Piece Surround Panel
See SKUs Below
Height
Custom
30.5"
34"
17601905 - Printed 10/6/15
Width
Custom
42"
44"
Attach the brackets with the
included screws.
Hint: pre-thread the holes
prior to installing the brackets.
5/16" Nutdriver
© Travis Industries, Inc.