FBB4 OPTIONAL VARIABLE SPEED BLOWER INSTALLATION
JUNCTION BOX WIRING INSTALLATION INSTRUCTIONS
All wiring should be done by a qualified electrician and shall
be in compliance with all local, city and state building codes.
Before making the electrical connection, make sure that main
power supply is disconnected. The appliance, when installed,
must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the national electrical
code ansi/nfpa 70 (latest edition).
A factory installed junction box is located on the lower right side of
the fireplace. Wiring must be fed to the junction box and attached
to the receptacle that is provided. Leave approximately 6" of wire
in the junction box for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (ground) screw.
Install the receptacle into the junction box. Attach cover plate.
39357-0-1018
FAN
SWITCH
WHITE
CAUTION
1
2
3
4
110 VOLT AC
JUNCTION BOX
FAN
BLACK
SPEED
CONTROL
R7731
BLOWER MOTOR
31920
SWITCH ASSEMBLY
R4192
SPEED CONTROL kNOB
R4186
SPEED CONTROL
GROUND
Figure 96
Page 91