Table of Contents
Advertisement
JUNcTION BOX wIRING INSTALLATION INSTRUcTIONS
cAUTION: ALL wIRING SHOULD BE DONE BY A QUALIFIED ELEcTRIcIAN AND SHALL BE IN cOMpLIANcE wITH ALL LOcAL,
cITY AND STATE BUILDING cODES. BEFORE MAKING THE ELEcTRIcAL cONNEcTION, MAKE SURE THAT MAIN pOwER SUppLY
IS DIScONNEcTED. THE AppLIANcE, wHEN INSTALLED, MUST BE ELEcTRIcALLY GROUNDED IN AccORDANcE wITH LOcAL
cODES OR, IN THE ABSENcE OF LOcAL cODES, wITH THE NATIONAL ELEcTRIcAL cODE ANSI/NFpA 70 (LATEST EDITION)
A factory installed junction box is located on the lower right hand
side of the firebox. Wiring must be fed to the junction box and
attached to the receptacle that is provided. Remove the knockout
in the installed junction box to accept wiring into the junction box.
Install a UL listed cable clamp (not supplied) in the knockout
hole. Leave approximately 6 inches of wire in the junction box
for connection.
Attach black wire to one side of the receptacle and white wire to
opposite side of receptacle. The ground wire should be attached
to the green (neutral) screw.
Install the receptacle into the junction box. Attach cover plate.
Keep the control compartment, logs and burner area surrounding
the logs clean by vacuuming or brushing area at least twice a year.
THE LOGS CAN GET VERY HOT – HANDLE ONLY WHEN COOL.
Always turn off gas to the pilot before cleaning. For relighting, refer
to lighting instructions located on the log set.
Page 16
MAINTENANcE
Never obstruct the flow of the combustion and ventilation air. Keep
the front of the firebox clear of all obstacles and materials.
Screens must be closed during operation.
Figure 27
33637-2-0215
Advertisement
Table of Contents
