Table of Contents
Advertisement
3. The status bar shows the progress of the dehumidification
program.
4. End the dehumidification program.
The following messages are displayed:
Dehumidification program successful
Dehumidification program failed
When the dehumidification program is active, the furnace head is automatically opened and closed during the
program. This supports the evaporation of condensed water. Do not interrupt this procedure.
5.4.7.2
Cleaning program
The cleaning program is used to "clean" the heating muffle (duration: approx. 17 min). After a cleaning program, it is
recommended to calibrate the furnace. In case of problems with discolouration of the ceramic, we recommend replacing
the firing table or the firing tray material.
To start the cleaning program, proceed as described in the section on the dehumidification program.
5.4.8 Operating mode
In the Settings menu, various operating modes can be selected. This increases the reliability of use and adjusts the furnace
to the area of application. The following modes are available:
– Standard: All functions of the ceramic furnace are available in this mode.
– Protected: Only programs can be selected and started in this mode. Programs cannot be changed. Settings or special
functions cannot be activated or changed. The safe mode can only be activated or deactivated by entering the user
code.
– Production: In this mode, only one program can be accessed. Only the functions Open/Close furnace head and Start/
Stop program are available. Only that program is available, which was loaded in the furnace at the time the production
mode was activated. Help notes on the operation are shown in the display. The production mode can only be activated
or deactivated by entering the user code.
The selection of the operating mode requires only few steps:
1. Changing the operating mode
Open the Setting menu and press the button in the line
"Operating Mode".
5. Operation and Configuration
57
Hide quick links:
Advertisement
Table of Contents
