Ivoclar Vivadent Programat P710 Operating Instructions Manual page 33

5. Operation and Configuration
Gloss function
In addition to the usual program parameters, the Ivoclar Vivadent Gloss programs feature a gloss function. This function
can be activated by means of the [Gloss Level] button. After the function has been activated, the gloss of the restoration
can be gradually increased (ten gloss levels). This prolongs the holding time of the corresponding firing step. The
temperature remains unchanged by this setting. The gloss level is reset after every firing cycle or program change.
Proceed as follows to set the gloss level:
1. Press the [Gloss Level] button
A gloss level chart opens. The red bar indicates the selected gloss
level. If the red bar is on the far left (basic setting), no level has been
selected and the gloss function is not yet active.
2. Press the [Plus] button to increase the gloss of the
restoration
Automatic plausibility check of the parameters
The furnace is equipped with an automatic plausibility check function. The parameters are checked upon each program
start. In case of contradictory parameter combinations, the program stops automatically and the respective note is shown.
33