Set-Up Instruction - Honda HRJ196 Manual

42VL96000.book 59 ページ ２０１２年１０月５日 金曜日 午前１０時７分
Unpacking
Remove all protective cardboards from the mower, including the piece
around the handlebar.
Grass Bag Installation
Refer to page 54 for grass bag installation.
Handlebar Setup
1.Remove the handlebar locking knobs from the handlebar mounting
section of the cutter housing.
2.Set the lower section of the handlebar to the handlebar mounting
section of the cutter housing enough so you can raise the handlebar
into the normal position.
3.Loosely install the washers and handlebar locking knobs.
4.Raise the handlebar in place.
5.Tighten the handlebar locking knobs securely.
6.Install the rope guide to the handlebar, and then tighten the flange
bolt and lock nut securely.
7.Remove the wire bands from the cables.
8.Install the air cleaner hose to the air cleaner cover and throttle lever
cover (PWDH Type).
ROPE GUIDE
AIR CLEANER HOSE
(PWDH Type)
AIR CLEANER COVER

10. SET-UP INSTRUCTION

FLANGE BOLT
LOCK NUT
HANDLEBAR LOCKING KNOB (2)
WIRE BAND (5)
THROTTLE LEVER
COVER
HANDLEBAR
WASHER (2)
59