42VL96000.book 51 ページ 2012年10月5日 金曜日 午前10時7分
Installation
1.Clean dirt and grass from the blades, blade disc, and the inside on the
cutter housing.
2.Install the blade, spring washer, blade washer and self-lock nut to the
blade disc using the blade setting bolt as described below.
SELF-LOCK NUT (2)
BLADE WASHER (2)
SPRING WASHER (2)
BLADE (2)
BLADE SETTING BOLT (2)
3.Tighten the self-lock nuts with a torque wrench. Prevent the blade
disc from turning when tightening the self-lock nuts, tighten the
self-lock nuts to the specified torque.
The blade setting bolts are specially designed for the mower.
Should you ever have to replace them, use only Honda genuine parts.
Otherwise, the blade may detach from the mower and cause serious
injury.
Self-lock nuts tightening torque:
34.3 N∙m (3.5 kgf∙m)
BLADE DISC
51