Blade Removal And Installation - Honda HRT216TDA Harmony II Owner's Manual

SERVICING YOUR MOWER

Blade Removal and Installation

If you remove the blade(s), use a torque wrench for installation. Wear
heavy gloves to protect your hands. To avoid weakening the blade(s),
or causing imbalance or poor cutting, the blade(s) should be
sharpened by trained staff at an authorized Honda servicing dealer. If
replacing the blade, use a genuine Honda replacement blade(s) or
equivalent.
Blade Removal
1. Turn the fuel valve to OFF. Disconnect the spark plug cap, then tilt
the mower to the right side (carburetor side up).
2. Remove the two blade bolts with a 14 mm socket. Use a wooden
block to prevent the blade(s) from turning when removing the bolts.
Remove the blade(s) from the blade holder.
HRS
HRR, HRT, HRZ
Always use an upper and lower blade on the HRR, HRT, and HRZ models.
32
BLADE HOLDER
SINGLE BLADE
SPECIAL
WASHER (2)
BLADE
BOLT (2)
BLADE HOLDER
UPPER
BLADE
LOWER
BLADE
SPECIAL
WASHER (2)
BLADE
BOLT (2)