Honda HRJ196 Manual page 53

42VL96000.book 53 ページ ２０１２年１０月５日 金曜日 午前１０時７分
Tighten the blade disc holder bolt with a torque wrench. Set a flat
blade screwdriver at the engine's bolt to prevent the blade disc from
turning when tightening the blade disc holder bolt, tighten the blade
disc holder bolt to the specified torque.
Blade disc holder bolt tightening torque:
53.9 N∙m (5.5 kgf∙m)
6.After installing the blade/blade disc check that it does not interfere
with the cutter housing. If the blade contacts the cutter housing,
consult your servicing dealer.
A bent blade can be the cause of serious personal injury or accident.
If you don't have a torque wrench, have your servicing dealer tighten
the blade setting bolts and the blade disc holder bolt before you use
the mower. If the blade setting bolts and the blade disc holder bolt
are overtightened, they could break. If the blade setting bolts and the
blade disc holder bolt are not tightened enough, they could loosen or
come out. In either case, it would be possible for the blade to fly off
while you are operating the mower.
53