Table of Contents
Advertisement
VDSL CO(POINT TO POINT)
General Rules
Before making any connections to the converter, note the following rules:
Ethernet Port (RJ-45)
All network connections to the Converter Ethernet port must be
made using Category 5 UTP for 100Mbps; Category 3,4 UTP for
10Mbps
No more than 100 meters of cabling may be use between the MUX
or HUB and an end node.
VDSL Port (RJ-11)
All Home network connections to the RJ-11Port made using 24~26
Gauge phone wiring.
We do not recommend using 28 Gauge or above phone line.
Connecting the Converter
The converter has one Ethernet port which support connection to
Ethernet operation. The devices attached to these ports must support
auto-negotiation or 10Base-T OR 100Base-TX unless they will always
operate at half duplex.
Use any of the Ethernet ports to connect to devices such as NIC,
Switch, bridge or router. You can also connect to another compatible
converter to an RJ-45 port on the other device.
The RJ11 Line port are use to connect to the wall RJ-11 modular
socket which is connect to VDSL CPE converter side (Point to point
solution)
The RJ11 Phone port of the converter can connected to a telephone
and a computer sharing one telephone wire for making calls and
accessing the internet at the same time.
6
USER'S MANUAL A.9
Advertisement
Table of Contents
