Table of Contents
Advertisement
VDSL CO(POINT TO POINT)
Power and Cooling Problems
If the POWER indicator does not turn on when the power cord is
plugged in, you may have a problem with the power outlet, power
cord, or internal power supply as explained in the previous section.
However, if the unit power is off after running for a while, check for
loose power connections, power losses or surges at the power outlet,
and verify that the fan on back of the unit is unobstructed and running
prior to shutdown. If you still cannot isolate the problem, then the
internal power supply may be defective. In this case, contact your
dealer.
Installation
Verify that all system components have been properly installed. If
one or more components appear to be malfunctioning (e.g., the power
cord or network cabling), test them in an alternate environment where
you are sure that all the other components are functioning properly.
Transmission Mode
The default method of selecting the transmission mode for RJ-45
ports is 10/100 Mbps ETHERNET, for RJ-11 port are 10Mbps VDSL.
Therefore, if the Link signal is disrupted (e.g., by unplugging the
network cable and plugging it back in again, or by resetting the
power), the port will try to reestablish communications with the
attached device via auto-negotiation. If auto-negotiation fails, then
communications are set to half duplex by default. Based on this type
of industry-standard connection policy, if you are using a full-duplex
device that does not support auto-negotiation, communications can
be easily lost (i.e., reset to the wrong mode) whenever the attached
device is reset or experiences a power fluctuation. The best way to
resolve this problem is to upgrade these devices to a version that
support Ethernet and VDSL.
33
USER'S MANUAL A.9
Advertisement
Table of Contents
