Table of Contents
Advertisement
VDSL CO(POINT TO POINT)
This section describes the important parts of the converter.
It features the front indicators and rear connectors.
Front Indicators
The following figure shows the front panel.
At a quick glance of the front panel, it is easy to tell if the CO
converter has power, if it has signal from its Ethernet RJ-45 port and
if there is phone line signal on RJ-11port
LED Description and Operation. The Converter has three LED indicators
LEDs
Ready
(Ready LED)
Ethernet
(Ethernet LED)
VDSL
(VDSL LED)
3.Hardware Description
Figure Chapter 2.2 Front Indicators
Status
Steady
Green
Steady Green
Flashing
(LINK/ACT)
Steady Green
Descriptions
It will light up (ON) to show that the
product is power good, and system reset
OK.
Each RJ45 station port on the Ethernet is
assigned an LED light for monitoring port
"Good Linkage". LED is normally OFF
after the power on operation, but will light
up steadily to show good linkage and
flashing to show data transmission.
RJ11 station port on the VDSL is assigned
an LED light for monitoring port "Good
Linkage". LED is normally OFF after the
power on operation, but will light up
steadily to show good linkage.
9
USER'S MANUAL A.9
.
Advertisement
Table of Contents
