Appendix D Speed Change Quick Guide - Dynamix VC-M User Manual

VDSL CO(POINT TO POINT)
Appendix D：SPEED CHANGE QUICK GUIDE
I. Please follow the procedures below step by step to change the speed
settings of VDSL CO & VDSL CPE:
1. Power on both VDSL CO & VDSL CPE
2. Connect each others over phone wire (PLEASE USE ENCLOSED
PHONE WIRE)
Note: Please remove PBX(voice)signal when running speed change
function.
3. Wait for a while and check if both link LEDs are on.(Default on 10M
mode)
4. Plug in one end of the console cable(RJ-45) to VDSL CO then connect
the other end(RS-232) to PC/Laptop's RS-232 COM port
5. Insert the diskette and select the VDSL Configuration Software
6. Run speed change utility program with Microsoft Win95/98/2000/NT/XP
OS
7. Double click on the VDSL Configuration Software Icon, you will see
Figure 1.1, please select which COM port you have connected & click OK
8. You will now see Figure 1.2
9. Click Link Configuration to enter Figure 1.3
10. Select speed mode according to your requirement
* Speed mode=Line Rate
11. Check phone wire length limitation:
4/1M 1900 meters = 6270 feet
5M 1500 meters = 4950 feet
10M 1200 meters = 3960 feet(default)
15M 1000 meters = 3300 feet
12. Click "Apply" to confirm settings
13. VDSL CO & CPE's LEDs will be off
14. Wait for around 1 minute
15. Check if the LEDs of both VDSL CO &
VDSL CPE are on
16. If yes, the speed change is done successfully
USER'S MANUAL A.9
Figure 1.1
Figure 1.2
35
Figure 1.3