Cage Weigh System (If Fitted) - nifty TrackDrive TD120T Series Operating/Safety Instructions Manual

TrackDrive (TD) Series
Operating & Safety Instructions
4.5

CAGE WEIGH SYSTEM (If fitted)

4.5.1 LOAD CELL
The Niftylift TD120T is fitted with an electronic load cell. This load cell is a moment-independent
design. This means that independent of the load position inside the machine cage, the actual load is
measured and if pre-calibrated limit values are exceeded, warnings will be activated. If load exceeds
the safe working limit (SWL) of the machine, the machine will be disabled until the load is reduced to
below 95% of the safe working limit. The design of the unit meets the requirements of both BS EN280
and ISO 13849 with a safety integrity level of "Category 3 PL d. (Refer to Appendix A)
4.5.2 CALIBRATION, INSPECTION AND MAINTENANCE
Calibration, maintenance and repair of the Niftylift TD120T cage load cell requires specialist knowledge
and equipment. For this reason, no part of the Niftylift TD120T cage-weigh system can be
adjusted, repaired or inspected by the operator.
All enquiries relating to calibration, inspection or maintenance should be directed to Niftylift or one of
their approved dealers. Contact details are listed in Section 1.3.
32
English/USA – 02/17