nifty TrackDrive TD120T Series Operating/Safety Instructions Manual page 36

TrackDrive (TD) Series
Operating & Safety Instructions
4.6.2 CRANEAGE
1) Observe all of the limitations relating to straps and chains stated above under 'Transporting'.
(Section 4.6.1)
2) When utilising the designated lifting points never apply a 'snatch' load, i.e. lift slowly to take up
the load before raising. Similarly, do not drop machine when positioning after lifting.
3) If the machine is to be lifted by crane, use the designated lifting points and observe the
recommendations regarding spreader beams. Individual drawings are available for each machine
type, on request. (See list below.)
4.6.3 STORAGE
If being stored for any length of time without use, then the machine should be thoroughly inspected for
the following: -
1) Grease all bearings /slides, worm drives, etc.
2) Check batteries for electrolyte levels, state of charge, damage, dirt, etc. Never leave in a state of
discharge for any length of time. If no use of the platform is intended, an occasional "top-up"
charge of the batteries will serve to equalise their charge level.
3) Leave diesel engine switch in the OFF position to prevent discharge of batteries through leakage.
4) If machine is to be left on an incline, chock the track to prevent creep.
5) If machine is to be left out-of-doors or in a hostile environment, cover with suitable weatherproof
media to prevent deterioration.
4.6.4 SETTING TO WORK
Before use each day and at the beginning of each shift the machine shall be given a visual and
functional test including, but not limited to, the following
1) Check all lubrication points for adequate application of grease, oil etc.
2) Inspect all threads for ease of operation.
3) Check level and quantity of oil. Remove any contaminants - water, etc.
4) Check batteries for electrolyte and state of charge.
5) Check electrics for damage and insulation.
6) Using base controls, cycle machine over complete envelope in accordance with the Operating
Instructions. Cure any defects.
7) Ensure that all safety devices and controls operate in accordance with the instructions.
8) If necessary, perform a load test to establish the machine stability before putting the machine to
work.
34
D80932 TD120T
English/USA – 02/17