1000Base-T Sfp Specifications - Avaya 4800 Series Installing

SFP specifications
Parameter
Framing
Rx sensitivity
Yellow alarm
Fault propagation
Tx disabled behavior
Transmit AIS
Important:
You must configure the T1 SFP module to match the parameters of the T1 equipment at the far
end. If you must change the parameters, contact Avaya Technical Support.

1000BASE-T SFP specifications

The 1000BASE-T SFP provides gigabit Ethernet connectivity using a single eight-pin RJ-45
connector. The 1000BASE-T SFP model AA1419043-E6 operates at 1 Gbps.
Note:
AA1419043-E6 operates at 1 Gbps, and can support 100 Mbps in the following units:
• ERS 4826GTS
• ERS 4826GTS-PWR+
• ERS 4850GTS
• ERS 4850GTS-PWR+
Important:
Avaya recommends setting all 1000BaseT ports to auto-negotiate in accordance with the IEEE
802.3ab standard. By default, SFPs inserted into certain product-specific modules are set for
autonegotiation = True.
The maximum current requirement of the SFP is 375 milliamperes (mA) at 5 volts (V).
The following table describes the 1000BASE-T SFP specifications.
Table 8: IEEE 802.3z 1000BASE-T SFP specifications
Parameter
Standards
Connectors
Cabling
Distance
August 2016
Default setting
1 (ESF)
1 (limited long haul)
0 (normal operation)
0 (normal operation)
2 (Alarm Indications Signal—AIS)
0 (normal operation)
Installing Transceivers and Optical Components on Avaya ERS 4800 Series
Comments on this document? infodev@avaya.com
Specifications
IEEE 802.3z, IEEE 802.3ab
RJ-45
CAT5E or better UTP
Up to 100 m
38