Adapter Identification; Abbreviations - Broadcom Emulex LPe12000 Series Installation Manual

Host bus adapters
Hide thumbs Also See for Emulex LPe12000 Series:
Table of Contents

Advertisement

Emulex LPe12000-Series Host Bus Adapters Installation Guide

1.5 Adapter Identification

Each adapter ships with several numbers clearly marked on the circuit board. Record the following numbers before
installation.
Serial number – Assigned by Emulex. Use this number when communicating with Broadcom Technical Support.
IEEE address – An IEEE unique 64-bit identifier used for system configuration.
WWN – Derived from the IEEE address; the FC industry uses the WWN for FC connectivity.
NOTE:
IEEE addresses and WWNs are assigned in sequential order. For example, if an adapter has four ports, it has four
IEEE addresses and four WWNs; one for each port. The second, third, and fourth IEEE addresses and WWNs are
the next successive number after the first.

1.6 Abbreviations

Table 2: Acronyms and Abbreviations
Acronym/Abbreviation
CEM
Gb/s
GT/s
ID
RMN
Broadcom
Description
Card Electromechanical
gigabits per second
giga-transfers per second
identification
regulatory model number
LPe-120XX-IG124-100
3

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Emulex LPe12000 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Emulex lpe12004Emulex lpe12002

Table of Contents