Removing The Existing Handgun - Nordson AD-31 Series Product Manual

Repair
7-37
Removing the Existing
Handgun
4110132
Fig.7-58
Locking Out
lnput Power
CAUTION: The Nordson handgun, sensor, and cordset
are not
compatible with similar components of other brands; therefore,
to prevent a possible hazard when replacing an existing
non-Nordson handgun with
any Nordson RTD handgun, you will
need
to obtain and installa cordset conversion
kit.
See
your
Nordson
representative. Possible hazards include runaway
temperature and failure to obtain an adequate ground.
Before removing
the existing handgun, gather the following:
o
appropriate protective clothing
.
3-mm (1/B-in.) Phillips screwdriver
o
2o-mm (s/4-in.) open-end wrench
o
18-mm (11/16-in.) open-end wrench
1.
Make sure that
you have followed the above procedure, Relieving
Hydraulic
P
ressure, before proceeding.
WARNING:
Risk of
electricalshock.
Failure
to observe this
warning
can result in personal injury or death.
2.
Set the applicator circuit breaker
or
the disconnect switch to the OFF
position.
WARNING: Even when switched off, Nordson applicators and
guns contain electrical potentials that can cause death.
Disconnect and lock
out power to the applicator main circuit
breaker.
3.
Disconnect
and lock out the input power line to'the applicator main
circuit breaker.
@ 1995 Nordson Corporalion
All rights reserved
42-72
lssued
10/95
ATEN{8-[AD-31EX]-1