Table of Contents
Advertisement
7-42
Repair
lnstal li
ng
the Replacement
Handgun
CAUTION: The
Nordson handgun, sensor, and
cordset are not
compatible
with similar components of other brands;therefore,
to prevent a possible hazard when replacing an existing
non-Nordson handgun
with any Nordson RTD handgun,
you
will
need
to obtain and install
a
cordset
conversion
kit.
See
your
Nordson
representative. Possible hazards include runaway
temperature and failure to obtain an adequate ground.
Before installing
the
replacement handgun, gather the following:
.
appropriate protective clothing
.
3-mm
(1/B-in.)
Phillips
screwdriver
.
2o-mm
(s/a-ln.)
open-end wrench
o
18-mm
(1U16-in.)
open-end wrench
1.
Make sure
that
a
You have followed
the procedure, Relieving Hydraulic Pressure,
before proceeding.
a
a
The applicator circuit breaker is
in
the OFF position
The input power
line
to
the applicator main circuit breaker
is
disconnect and locked out.
CAUTION:
Ensure
that each set of electricalwires exiting the
hose aligns
with
a
groove
on
the pivot sleeve
so
that the wires
do
not
twist around the base
of
the
pivot
sleeve.
lmpioper
alignment
can damage the wires, resulting
in
a possible
electrical short.
2.
Align
the pivot sleeve and the
hose so that
the grooves along the
sides
of
the pivot sleeve line
up
with each set
of
wires exiting the
hose.
Make sure
to route the set
of
wires containing the ground
wire
up
the groove on the heater
side
of
the pivot sleeve.
NOTE:
Handguns
with a
thermostatic sensor use only one
set of electrical wires.
4203084
Fig.
7-64
ProperWireAlignment
42-72
lssued 10/95
@
1995 Nordson
Corporation
All
riqhts
reserved
ATEN-08-[AD-31ER-1
Hide quick links:
Advertisement
Table of Contents
