Modular Closets Corner Tall Hanging Unit Assembly And Installation Instructions Manual page 6

ASSEMBLY AND INSTALLATION INSTRUCTIONS
CORNER TALL HANGING UNIT
8
8.1
Rotate assembled unit 90 degrees to allow for
installation of Right Side Panel.
8.2
Assemble Upper Rear Hanging Cleat (F) and Lower
Rear Hanging Cleat (G) onto assembled Vertical Brace
by sliding parts onto the Cam Posts (K) on Brace. BE
SURE dowel pins in Cleats engage drilled holes in Brace,
and parts are pressed flush against Brace.
8.3
Insert Camlocks (L) in holes in two Rear Hanging Cleats (G), with arrow pointing toward Cam Post opening.
Be sure Camlocks engage Cam Posts, and are fully seated.Tighten Camlocks (L) clockwise to lock.
9
9.1 Install Right Side Panel (B) onto assembled Set Shelves
(E) and Upper and Lower Rear Hanging Cleats (F, G).
BE SURE dowel pins in Shelves and Cleats engage drilled
holes in Side Panel, and Side Panel is pressed flush against
Set Shelves and Cleats.
ARROW TOWARD
CAM POST OPENING
F
L
K
B
F
E
E
G
L
G