Rj45 Management Port; Rj45 Management Leds; Reset Button - Lenovo RackSwitch G8272 Installation Manual

RJ45 Management Port

RJ45 Management LEDs

Reset Button

24
G8272 Installation Guide
The RJ45 management port on the front panel supports 10/100/1000 Mbps BASE-T,
in-line switch management.
To attach an RJ45 connector to the switch, push the RJ45 cable connector into the
port connector until it clicks into place.
To disconnect the RJ45 cable, squeeze the release tab and gently pull the cable
connector out of the switch connector.
The RJ45 management port LEDs are oriented as shown in the following figure.
Figure 5. RJ45 management port LEDs
Speed LED
Status LEDs for the RJ45 management port are described in the following table.
Table 3.
RJ45 status LEDs behavior
LED State
Steady Green
Link/Activity Flashing Green Packet transmitting or receiving
Off
Steady Green
Speed
Off
The Reset button is recessed within a hole on the front panel. Use a straightened
paper clip or similar object to press the Reset button. The Reset button allows
technicians to reset the switch as follows:
 Normal reset—press and release the Reset button. The switch starts a forced
reload procedure without saving the current running configuration. This action
is intended for when the switch is unresponsive and needs to be restarted to
resume its normal functions.
 Factory reset—press and hold the Reset button for more than five seconds. The
switch reloads and reverts all its configuration settings to the factory defaults.
Link/Activity LED
Functional Meaning
Link up
Link down or port disabled
1000 Mbps connection
10/100 Mbps connection or no link