In-Band Management Interface Configuration - Lenovo RackSwitch G8272 Installation Manual

In-Band Management Interface Configuration

1. Log onto the switch using the serial console port or management port on the G8272
front panel.
2. Enter the SVI interface configuration mode:
3. Configure the in-band management IP address:
4. Configure the in-band default gateway:
© Copyright Lenovo 2019
Complete the following steps to configure an in-band management IP address over
an SVI interface and an associated default gateway:
Note: This method is only available on CNOS.
G8272> enable
G8272# configure [terminal]
G8272(config)#
G8272(config)# interface vlan 1
G8272(config-if)# ip address 10.254.87.6/24
G8272(config-if)# exit
G8272(config)#
G8272(config)# ip route 0.0.0.0/0 205.21.17.1
Chapter 5: Initializing the G8272
81