Lenovo RackSwitch G8272 Installation Manual page 43

For lenovo network operating system

Hide thumbs Also See for RackSwitch G8272:

Table of Contents

1. Locate, record, and retain the product switch information in order to configure and

2. Remove the rear cover screws:

3. Attach the front mounting brackets (Item 1) to each side of the switch with M4

screws (Item 2). Torque the screws to approximately 2.0 newton-meters (Nm) ± 0.1

Nm (17.7 inch-pounds).

To install the G8272 in a System x or Power rack, complete the following steps:

Note: If this switch is a replacement switch, copy the product information from the

original switch onto the RID label that is shipped with replacement switch and

affix the new label to the bottom of the new switch.

"Before Installing the G8272" on page

Chapter 3: Installing G8272 Hardware and Options

34.

Table of Contents