Table of Contents
Advertisement
8
Maintenance / Troubleshooting
8.1
Status retrieval
8.2
General maintenance work
8.3
Resetting
Fire Safety & Security Products
The manual call points are provided with an MC-Link. With this link, proximity
exchange of data is possible over short distances between the manual call point
and the detector exchanger and tester.
The following actions can be performed from the control panel:
Commissioning
Read error list / status register
The following maintenance work must be performed on an annual basis:
Check all detectors for mechanical damage.
Replace defective detectors.Carry out a performance check.
After alarm activation the manual call point must be set in operational availability
again. This procedure is different for each of the two detector types.
FDM221
To set the detector back to operational availability, proceed as follows:
1. Open the housing.
2. Remove the glass pane.
3. Insert a new glass pane.
4. Close the housing.
5. Carry out a performance check.
1
7BMaintenance / Troubleshooting
007002_e_en_--.doc
23
11.2007
Hide quick links:
Advertisement
Table of Contents
