Connecting The Camera - Lorex LZV2925 Instructional Manual

3 Connecting the Camera

When you first power up the camera and connect it to the DVR, it may take
up to two minutes for the camera image to appear.
It is recommended to connect the camera to your DVR and test the PTZ
controls before permanent installation. For instructions on how to set up
PTZ controls, see 5 Controlling the PTZ Camera with a Lorex MPX DVR,
page 13.
1. Connect the BNC video connector on the camera cable to the included
extension cable.
NOTE
The included extension cable is built for this camera and guarantees
proper video / power connection.
2. Connect the female 12V DC power connector on the camera cable to
the male power connector on the included extension cable.
3. Connect the BNC cable on the extension cable to one of the Video In-
put ports on the DVR. Make note of the port number where you con-
nect the camera, as it will be used when configuring the DVR to
communicate with the camera.
#; r. 9.0/56187/56187; en-US 4