Connecting The Camera; Option 1: Connecting The Camera To An Nvr; Option 2: Connecting Cameras To The Local Area Network (Lan) - Lorex LNZ81P25 Series Instruction Manual

Hide thumbs Also See for LNZ81P25 Series:

Table of Contents

Connecting the Camera

NOTE

It is recommended to connect the camera to your NVR and test the PTZ controls before permanent installation.

For instructions on how to set up PTZ controls, see 5 Controlling the PTZ camera with the N883 Series NVR,

page 15.

May not be exactly as shown

1. Connect the PoE+ connector on the camera cable to an Ethernet extension cable.

2. Connect the Ethernet extension cable to one of the PoE+ ports on the back panel of your

NVR.

NOTE

•

You can use up to a 300ft (91m) CAT5e Ethernet cable to connect the camera to your NVR (not

included).

•

For the most up-to-date list of compatible NVRs, please visit

3. Alarm: Connect the camera to an alarm system using alarm output (blue), alarm communi-

cation (green), alarm ground (yellow and green), alarm input (red and/or brown).

4. Audio: Connect the camera to external audio device using audio output (red), audio input

(white), and audio ground (black).

For flexibility, you may also connect the camera to the same Local Area Network (LAN) as the

NVR. This is accomplished by connecting the camera to the same router as the NVR. For these

installations, an external PoE+ switch (sold separately) or power adapter (included) must be used

to provide power to the camera. You also must add the camera on the NVR before it will show a

picture on the monitor or be recorded by the NVR.

#LX400116; r. 4.0/60127/60127; en-US

lorex.com/compatibility.

Table of Contents