Dvr (Cvbs); Changing The Camera's Ptz Protocol Information For Analog Dvrs (Cvbs) - Lorex LZV2925 Instructional Manual

6 Changing PTZ Protocol and Video Format
6.3 Changing the Camera's PTZ Protocol Information for Analog
DVRs (CVBS)
Change the default protocol information on your PTZ cameras only when
using multiple PTZ cameras or if your DVR does not support the default
settings (see your DVR's instruction manual for details).
The PTZ protocol information on this camera is set using DIP switches in-
side the camera. DIP switches represent binary values. This means that they
are either On (1) or Off (0).
The DIP switches control 3 values:
1. Camera ID (Address): The ID of the camera, which allows the DVR
to identify different PTZ cameras. You cannot use the same ID for
more than 1 PTZ camera, and you cannot set an ID value of 0.
2. Baud Rate: The baud rate, which is the frequency of communications.
3. Video Standard: For CVBS recorders, you must set the video standard
to SD (CVBS). See 6.3.4 Switch Between Analog Video Formats, page
26 for details.
NOTE
The parity value for this camera is NONE. Parity cannot be
configured.
#; r. 9.0/56187/56187; en-US
1 3
2
23